Starmask mouth mask filter - Solvent filter - Vosschemie Soloplast

Starmask mouth mask filter - Solvent filter - Vosschemie Soloplast

These replaceable filters ensure maximum protection , even during prolonged use.
These are activated carbon filters that provide protection when working with epoxy and polyester and when sanding .

Applications:

• The face pieces of the carsystem Star series of masks meet the requirements of the EN140 approved standard.
• The vapor/gas filter cartridges and the particle cartridges meet the requirements of the respective approved standard EN14387:2004+A1:2008.
• Filter pads only meet the requirements of the approved standard EN14387:2004+A1:2008 when used in combination with steam/gas cartridges.
• 141.224 Filter cartridge protection class A2 Organic vapours, with a boiling point above 65°C, up to 50X OEL or 1000 ppm, whichever is lower.
• 141.154 Prefilter protection class P2SL
• For use as in the categories above and against dust and liquid based aerosols up to 10X OEL.

Treatment :

1. Choose the most suitable facepiece size.
2. Place the respirator over the mouth and nose (ensure that the top of the nosepiece is aligned with the bridge of the nose, the bottom of the facepiece goes under the chin, and the seal around the facepiece is in contact with the skin of the face)
3. Then pull the head harness over the top of the head.
   Fasten the lower straps behind the neck.
4. Tighten the top strap at the ends for a secure and comfortable fit.
5. Tighten the lower straps by pulling the ends or loosen them by pushing the buckle outwards.
6. Check the fit of your respirator each time you enter a contaminated area.

Security :

• This respirator does not supply oxygen.
• Do not use in an atmosphere containing less than 19.5% oxygen (or as determined by regulatory authorities) or an atmosphere which is or may become immediately dangerous to life or health.
• Do not use in an oxygen enriched atmosphere.