Sikacor-146 DW - Epoxy Coating - Sika

Sikacor-146 DW - Epoxy Coating - Sika

SikaCor-146 DW is a 2-part, fast-curing epoxy coating for use on steel and concrete . The coating is hard-elastic, resistant to mechanical influences and has resistance to abrasion, shock and impact.

SikaCor-146 DW is solvent-free according to the protective coatings guideline of the German Paint Industry Association (VdL-RL 04).

Features

• Certified for contact with drinking water, many foodstuffs, chemicals, cleaning agents and disinfectants
• Very good adhesion to steel, stainless steel, aluminum and concrete
• Economical – single layer system
• No complicated cure treatment before the system can be filled with drinking water
• Possibility of checking small holes/pinholes when applying to metal surfaces
• Does not contain benzyl alcohol

Application domain

SikaCor-146 DW is particularly suitable for the anti-corrosion protection of steel, stainless steel and aluminum surfaces, as well as for the protection of mineral surfaces consisting of concrete and cement coatings in direct contact with certain substances.

SikaCor-146 DW is mainly used as an internal lining for tanks, silos, containers, pipes (nominal diameter > 300 mm) and drinking water installations, as well as in the food and beverage industry.

Application

Blend

1. Carefully rehomogenize component A with an electric mixer.
2. Add component B at the recommended dose to component A and briefly mix the two components using an electric mixer at low speed (start slowly to avoid splashing, then increase speed to 300 rpm for intensive mixing ).
3. Mix for at least 3 minutes.
   The mixture is complete when a homogeneous mixture is obtained.
4. Pour the mixture into a clean container, then mix again briefly according to the instructions above.
5. Always wear a well-fitted face and eye mask, suitable gloves, and other protective clothing such as a long-sleeved top, work pants, and rubber apron when mixing and handling products.

Implementation

1. Dry film thickness is most easily obtained by airless spraying.
   Achieving the standard thickness and uniform appearance depends on the application method.
2. In general, spray application gives the best result.
3. Application by brush or roller may, to obtain the required thickness, require several coats.
4. This depends on the design, local circumstances and color.
5. Before starting the application, it is recommended to carry out a test on site to verify whether the result of the selected method is satisfactory.

Conditioning

12.6 kg: blue and beige.