MN Couleur Plus - Intensifies colors and deepens the structure - Lithofin

MN Couleur Plus - Intensifies colors and deepens the structure - Lithofin

Lithofin MN Color Plus is a special product for marble, natural stone and artificial stone.

It is a ready-to-use impregnating product based on silicones and special additives dissolved in organic solvents to enhance the colours.

Lithofin MN Color Plus penetrates the stone to make it water-repellent and enhance its color and structure without producing shine.

This product intensifies the color and gives a wet look. Once treated, the surface is more stain resistant and easier to maintain.

Lithofin MN Couleur Plus leaves no film, which allows vapor permeability to be maintained.

Technical specifications :

• Density: approx. 0.85g/cm³
• Appearance: colorless, transparent
• Smell: aromatic, gasoline
• Flash point: 36°C (cC)

Area of use :

Lithofin MN Color Plus is suitable for all absorbent and porous natural stones with a rough, sawn or honed finish such as granite, gneiss, porphyry, limestone, schist, Solnhofen slabs or artificial stone and concrete.

It intensifies the color of wall or floor coverings, stairs, terraces whose appearance is too bland or whose color must match that of a polished surface.

Please note: not suitable for non-absorbent, polished, highly honed or fired surfaces such as Dutch brick, porcelain stoneware, etc. If in doubt, test on an inconspicuous surface.

Manual :

1. Apply a thin even layer of Lithofin MN Couleur Plus with a clean roller, an applicator broom or a brush and allow to penetrate.
2. Highly absorbent surfaces may require a second coat.
3. A layer that is too thick may cause surfaces that are not very absorbent to shine. To avoid this shine, remove the excess with a lint-free cloth.

Note: Sensitive surfaces such as glass, wood, lacquer, plastic and the like must be protected from splashes. Do not apply in direct sunlight or at temperatures below 5°C and above 25°C.

Yield :

• approximately 7 to 15 m²/L.