Restore aero - Protective film - Zep Industries

Restore aero - Protective film - Zep Industries

Protective film based on acrylic lacquer which works as a transparent protective film of all kinds of surfaces against light acids, grease stains, fingerprints, alkali, dust, etc.
Plans, maps, important documents, etc. remain intact and perfectly readable.
Protects against dirty fingerprints and makes it waterproof.

Properties :

• With Zep Restore, plans, maps, important documents, etc. are saved. remain intact and perfectly readable.
  Protects against dirty fingerprints and makes it waterproof.
• Motors, wires and batteries treated with 'Zep Restore' are protected against moisture and rust, making motor maintenance easier.
• Zep Restore will not yellow or discolor over time; the original color of the treated support is not altered either.
• Good quality paneling is expensive: protect this investment in a simple way, with a coat of Zep Restore the original gloss will remain intact and stains, streaks and scratches can be removed with a damp cloth.
• A single coat of Zep Restore provides 6 months of protection. On metal, the product acts against corrosion.
• By using Zep Restore, surfaces are completely protected against the influence of humidity, either through condensation or rain

Applications:

Lamination of plans, photocopies, documents, drawings.
Protects printed circuits, electrical connections.
Against corrosion of metals exposed to bad weather, battery terminals, rubber exposed to water and oil splashes.

Manual :

1. Clean the support to remove impurities.
2. Shake before use.
3. Spray approximately 30 cm from the surface to be treated.
4. Apply several successive coats to obtain maximum protection.
5. Two thin coats are recommended rather than one thick coat.
6. Leave to dry for 10 minutes between each coat.
7. After spraying, invert the aerosol and purge to avoid blocking the valve.

Conditioning :

570 ml - Aerosol.