SikaFloor-300 Level - Levelling compound - 1 to 10 mm - Sika

SikaFloor-300 Level - Levelling compound - 1 to 10 mm - Sika

Cement- based self-leveling leveling mass with very low VOC emissions, for indoor application only.
Sikafloor-300 Level is characterized by its smooth finish, particularly low shrinkage and good self-leveling properties.
Suitable for medium duty.

Features

• Self-leveling
• Compatible with underfloor heating
• Layer thickness up to 20 mm if aggregates are added
• Resistant to office chair castors according to EN 12 529 in case of a thickness greater than 1 mm
• Pumpable
• High values of hardness and resistance
• Low surface porosity
• Very smooth application
• Can be sanded very easily
• Modified by polymers
• Hydration drying
• High capacity for smoothing irregularities in the substrate
• low voltage

Application areas :

Sikafloor-300 Level is suitable for smoothing, equalizing and leveling suitable substrates, before laying parquet, ceramic tiles, seamless floor coverings based on synthetic resin, textile or elastic floor coverings , and this inside residential and non-industrial buildings.

Application

1. Pour in the mixed leveling compound and spread using a trowel or notched scraper, or adjustable handle scraper.
   Then eliminate the air occlusions with the debubbling roller.
   When using an adjustable squeegee with a handle, it is generally not necessary to eliminate the traces left by the squeegee with a debubbling roller, or to level more than once.
2. Perimeter joints and expansion joints must be considered up to the finished surface.
   Avoid the introduction of equalization mass.
3. The leveling layer must be sufficiently thick and the surface sufficiently flat, as indicated by the manufacturer of the tiles or the floor covering.
4. In case of thicker layers, avoid contact with vertical structures by placing an insulation strip around the perimeter.
5. If a second leveling coat is to be applied, the first coat should be primed with Sikafloor-03 Primer or with Sikafloor-01 Primer (1:1).
   The maximum layer thickness cannot be exceeded when applying in two coats.
   The second layer cannot exceed the layer thickness of the first.
6. Avoid contact with metal, such as water pipes (eg by insulating the penetrations of the latter) because pipes made of galvanized steel in particular are not sufficiently protected against corrosion.
7. Protect Sikafloor-300 Level leveling layers from high ambient temperatures, direct sunlight and drafts (curing treatment).

Consumption

Approx. 1.5kg/m²/mm

Conditioning

25 kg bag.