Tiling Buddy - Complete shim and clip set 5-15 mm - Levelit

Step 1: Slide the clips under the tiles
After applying the glue, the clips are slipped under the tiles. You place one or more clips per side depending on the format of the tile. Position the tile by tapping it with a mallet.

Depending on the dimensions of the tile, it may be necessary to use several spacers on each side.

The use of two spacers per side is recommended for tiles of approximately 20 cm.

Step 2: Apply the wedges
Slide the shim into the opening of the crosspiece. Gently insert the wedges into the clips without going past the breaking point.

Step 3: Remove the clips
Allow 24 hours for drying after fixing!

Once the glue has completely dried and hardened, the still visible part of the spacers must be removed. To do this, cut the upper part of the crosspieces with a mallet or with your foot by striking the crosspiece with its wedge in the direction of the joint.

If you are using an instant adhesive, wait for the adhesive to do its job.